Murphy Flasher Alarm Light and Mini-Siren SAH - Manual (Page 2)

SAH
TL7
S SAH
Audio Alarm
Sensor Switch
(< 60 mA)
12 VDC or 24 VDC Battery
Typical Wiring Diagram
Below is a typical circuit diagram for the TL7 Flasher/Light and
SAH Mini-Siren. When the switch closes the lamp will flash and
the optional Mini-Siren will pulse at the same frequency.
NOTE: typical wiring with negative ground. Although designed
to be used with Murphy Swichgage, the TL7 can be used
with any dry contact type switch.
How to Order
When ordering a TL7, voltage and polarity must be specified
(see the diagram below):
Replacement Lamps for TL7
Voltage
Lamps
12 VDC 00-00-0029 #1815 or #53 type
24 VDC 00-00-0924 #1829 or #1820 type
TL7–12 N
Voltage
12 = 12 VDC
24 = 24 VDC
Polarity
N = Negative Ground
1/32 x 1/4 in.
(0.8 x 6 mm)
Male Push-on
Terminals (4 places)
2-7/8 in.
(73 mm)
1-1/2 in.
(38 mm)
1-11/16 in.
(43 mm)
1-5/8 in.
(41 mm)
1-1/4 in.
(32 mm)
Dimensions
TL7 SAH
Mounting Hole: 1-1/8 in. (29 mm) diameter
Maximum Panel Thickness: 1/4 in. (6 mm) Mounting Hole: 1-1/8 in. (29 mm) diameter
Maximum Panel Thickness: 1/8 in. (3 mm)
To order the SAH Mini-siren specify SAH.
WARNING
Before beginning installation of this Murphy product:
✔ Disconnect ALL electrical power to the machine.
✔ Make sure the machine CANNOT operate during installation.
✔ Follow all safety warnings of the machine manufacturer.
✔ Read and follow all installation instructions.
TL-8904B page 2 of 2
Warranty
A limited warranty on materials and workmanship is given with this FW
Murphy product. A copy of the warranty may be viewed or printed by
going to www.fwmurphy.com/support/warranty.htm
In order to consistently bring you the highest quality, full featured products, we reserve the right to change our specifications and designs at any time.
Printed in U.S.A. 0689774B
In order to consistently bring you the highest quality, full featured products, we reserve the right to change our
specifications and designs at any time. MURPHY, the Murphy logo, and Selectronic
® are registered and/or com-
mon law trademarks of Murphy Industries, Inc. This document, including textual matter and illustrations, is copy-
right protected by Murphy Industries, Inc., with all rights reserved. (c) 2006 Murphy Industries, Inc.
www.fwmurphy.com
918.317.4100 Email: [email protected]