Metz MF 72TL68 - Manual (Page 41)

41
wish to replace with the new station).
• Move the cursor to „Frequency/Channel“.
• Press the „OK“ key.
• In the setting window which is then displayed,
move the cursor to „Channel“ or „Special chan-
nel“.
• Enter the number of the channel or special
channel with the numeric keys.
• Press the „OK“ key to save the station.
• Press the „TV“ key to close the menu.
Fine tuning
When you programme stations, each channel is
automatically tuned to the centre frequency. This
is normally sufficient. If this automatic
function does not produce satisfactory
results, you can carry out fine tuning.
Executing fine tuning
• Select the desired programme position.
• Press the „MENU“ key.
• Press the white key
to open the sta-
tion table.
• Move the cursor to the subject card
„Frequency/Channel“.
• Press the „OK“ key to confirm your selection.
• In the setting window, select „Frequency“ and
use the - + key to change the frequency value
until the picture is as clear as possible.
• Save the new setting by pressing the „OK“ key.
• Press the „TV“ key to close the menu.
21. Programming stations Call the menu
MENU
OK
OK
Channel 6 Cable channel --
Frequency 182.31 MHz
Scan operation ARD
Change value
with + and –
Confirm with OK
Picture-Volume
AV devices
Station table
Timer
Configuration
TV
-Menü
Station table
‚ ‚ ‚
604 47 2017.A1 23.09.2004 14:45 Uhr Seite 41