M&S Systems 8-Ohm - Manual (Page 7)

Step 2. To begin installation of the speakers, first locate
the area where the wires are installed. At each location,
cut a hole to the dimensions shown for the model being
installed (Mounting Dimensions) in the tables found on
pages 1-3. The cutout should be centered in the stud
space opening. Prepare the speaker wiring by stripping off
approximately 3 inches of the outer jacket (care should
be taken so the insulation on the wires inside the jacket
are not damaged) also strip approximately 3/8 inch off the
ends of the two inside conductors. Twist the ends of the
stranded cable so the wires are tight.
Step 3. You are now ready to install the speaker. Re-
move the front grille from the speaker. (Be careful not
to touch the speaker cones in order to prevent any dam-
age). Attach the speaker cable to the speaker by pressing
down on the red (+) or black (-) tabs and inserting the
red wire in the red terminal and the black wire in the
black terminal. See Figure 1. Make sure that none of the
strands from the black and red wires are touching each
other. This can create a short circuit that can damage
your electronics. Index the mounting tabs to make sure
that all tabs will clear the opening. Insert the speaker in
the wall and tighten the tabs with the screws on the front
of the grille. DO NOT OVERTIGHTEN THE SCREWS,
the screws should only be tight enough to secure the
speaker.
Step 4. After the speaker is mounted, adjustments to
the swivel tweeter (small speaker) can be made by either
directing the sound visually or by using a musical source
to determine the best sound coverage for the listening
area. To position the tweeter, press at the outside edge
of the tweeter cone area (DO NOT PRESS ON THE
CONE DIRECTLY).
Page 6