Marantz RC2001 - Manual (Page 4)

2
ENGLISH
BEFORE USE
LOADING BATTERIES
Before using the remote controller for the fi rst
time, load the batteries in the remote controller.
The batteries provided are used to verify the
operations of the remote controller only.
Note:
The settings remain saved in the remote controller
even if the power completely runs out. However,
the time setting will be lost, and so please set the
time setting again.
1. Remove the battery case cover.
Battery case cover
2. Insert the new batteries (AAA type) with
correct ª and · polarity.
AAA type alkaline
batteries
3. Attach the battery case cover.
Battery case cover
CAUTION ON BATTERY
• Use AAA type batteries in this remote
controller.
• We recommend that you use alkaline batteries.
• If the remote controller does not operate from
close to the main unit, replace the batteries
with new ones, even if less then a year has
passed.
• The included battery is only for verifying
operation. Replace it with a new battery as
soon as possible.
• When inserting the batteries, be careful to
do so in the proper direction, following the +
and - marks in the remote controller s battery
compartment.
• To prevent damage or battery fl uid leakage:
- Do not use a new battery with an old one.
- Do not use two different types of batteries.
- Do not short-circuit, disassemble, heat or
dispose of batteries in fl ames.
• Remove the batteries when not planning to
use the remote controller for a long period of
time.
• If the batteries should leak, carefully wipe
off the fluid from the inside of the battery
compartment, then insert new batteries.
• When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction s rules that
apply in your country or area.