Meyer Sound HMS-10TM - Manual (Page 13)

13
CHAPTER 4: MOUNTING HMS-10 LOUDSPEAKERS
The HMS-10 comes standard with a fixed bracket; an
adjustable bracket is also available for wall mounting the
HMS-10 with downtilt or uptilt. This chapter describes how
to mount the HMS-10 with these two mounting options.
IMPORTANT SAFETY CONSIDERATIONS
When installing Meyer Sound loudspeakers, the following
precautions should always be observed:
■
All Meyer Sound products must be used in accordance
with local, state, federal, and industry regulations. It is
the owner’s and user’s responsibility to evaluate the reli-
ability of any rigging or mounting method for their appli-
cation. Rigging should only be carried out by
experienced professionals.
■
Use mounting and rigging hardware that has been rated
to meet or exceed the weight being hung.
■
Make sure to attach mounting hardware to the building's
structural components (studs or joists), and not just to
the wall surface. Verify that the building's structure and
the anchors used for the installation will safely support
the total weight of the mounted loudspeakers.
■
Use mounting hardware appropriate for the surface
where the loudspeaker will be installed.
■
Make sure bolts are tightened securely. Meyer Sound
recommends using Loctite
® on bolt threads and safety
cables.
■
Inspect mounting and rigging hardware regularly. Imme-
diately replace any worn or damaged components.
MOUNTING HMS-10 LOUDSPEAKERS WITH
THE FIXED MOUNT BRACKET
The HMS-10 can be mounted with a fixed mount bracket at
a fixed angle of 0 degrees. The low profile bracket allows the
HMS-10 to be mounted less than 0.6” (15 mm) from the
wall.
NOTE: When ordering the HMS-10 with the
fixed mount bracket, the bracket is factory
installed and already attached to the loudspeaker.
Fixed Bracket (OmniMount 17FM-F)
5.60
[142.24 mm]
3.00
[76.20 mm]
3.94
[100.00 mm]
5.10
[129.54 mm]
4.80
[121.92 mm]
0.50
[12.70 mm]
3.94
[100.00 mm]
Wall Plate
Loudspeaker
Plate