McIntosh XCS2K - Manual (Page 10)

10
Installation, con’t
7. With three persons, lift up on the sides and center rear
of the Low Frequency Enclosure part of the Loudspeak-
er. Place the Loudspeaker in the final location. Refer to
figure 11.
Adjusting the Elevation of the Loudspeaker
The acoustic output of the XCS2K Loudspeaker may be
directed to line up with the height of the average ear in the
prime viewing/listening area. There is a 30 degree range of
adjustment built-in.
1. Using an approprate tool, remove the hex head locking
bolt (used during shipping) from each side of the Loud-
speaker and retain them for possible future use. Refer
to figure 12.
2. While two
persons are
loosening
the hex head
adjustment
bolt on
each side of
the Loud-
speaker, a
third person
needs to as-
sist by stabilizing the front of the Loudspeaker.
3. Rotate the Loudspeaker so the center axis of the Loud-
speaker is pointed toward ear level when seated in the
main viewing/listening area. Figure 13 illustrates a fif-
teen degree angle and figure 14 is a thirty degree angle.
4. Tighten the adjustment bolt on both sides of the Loud-
speaker.
5. Reinstall the previously removed side covers.
6. Proceed to “How to connect” starting on page 12.
Figure 12
Locking
Bolt
Adjustment
Bolt
Top View of
Lift Areas
Figure 11
Figure 13
Figure 14