Miele KWL 4812 S - Manual (Page 27)

^ Rotate the door 180°.
^ Remove cover f and use it to cover
the now empty holes on the opposite
side.
^ Hang the door on the upper hinge
pin and close the door.
^ Fit the hinge bracket in the lower
door bearing. Then screw it securely
to the appliance plinth.
Use the long slots in the hinge
bracket to align the door.
Refitting the handle:
Please make sure you follow the
instructions below carefully when
you refit the handle. The door seal
will be damaged if the handle is
fitted incorrectly.
^ Loosely attach the handle to the
opposite side of the door with the two
front screws
b.
Mounting plate
c must be positioned
on the side of the door so that when the
door is
closed it is flush with the side of
the appliance.
If this is not the case,
^ Tighten both grub screws a with the
allen key provided until mounting
plate
c lines up correctly.
^ Then tighten all 4 fixing screws b.
^ Slide the side section of the handle
d into the guides on the mounting
plate until it clicks into place.
Changing the door hinging
27