MartinLogan Xstat Summit X User Manual
Page 14
The Summi X’s feet can be configured to adjust the rake
of the speaker from –1° to 11° allowing precise control of
the speaker’s vertical dispersion (figure 4).
Spike Installation Instructions:
1 Carefully lay your speaker on its side.
2 Remove existing feet. Thread the spikes into the holes
and screw them in all of the way. If the speaker does
not sit level loosen one spike until level is achieved.
3 Tighten the jam nut snugly by hand. Do not over tighten.
4 Right the speaker.
Caution: Make sure your hands and any cabling are
clear of the spikes. Do not slide speaker as spikes are
sharp and can damage your floor or carpet.
5 Adjust to level by rotating spikes. Tighten the jam nut
securely when satisfied that speaker is level.
14 Placement
A
B
C
D
–1°
1°
3°
5°
7°
9°
11°
A
D
B
D
A
B
C
D
B
A
D
B
D
A
Figure 4 . Spike installation.