Monster Power FlatScreen Mount SmartViewTM 300M - Manual (Page 12)

Installing the Wall Plate
Remove all pieces of the wall mounting system to ensure you have all
the necessary parts.
Be sure to choose a mounting location with easy access
to an AC power outlet.
Wood Stud Mounting:
Using an electronic stud sensor, locate two adjacent wall studs
at least 12" apart.
With the help of a friend, align the wall plate’s top and bottom
horizontal mounting slots over the center of each wall stud.
�����
�����
Level the wall plate with the bubble level.
Hold the plate fi rmly in place.
Mark the stud center in each of the four slots (bottom left,
top left, bottom right, top right).
With your electrical drill and 3/16" bit, pre-drill a 3" deep
hole at each mark.
Attach the wall plate to the wall using the lag bolts and round washers
as shown to the right. Tighten each bolt with your electric drill or socket
wrench. Turn clockwise until secure.
DO NOT over tighten bolts. This can damage the wall plate
or the surface of your wall.
DO NOT release the wall plate until you are absolutely certain
it is secured to the wall.
1)
2)
3)
4)
5)
6)
8