Maxtor DIAMONDMAXTM PLUS 5120 92048D8 - Manual (Page 34)

AT INTERFACE DESCRIPTION
5 – 23
Pin Description Table
PIN NAME PIN I/O SIGNAL NAME SIGNAL DESCRIPTION
RESET - 01 I Host Reset Reset signal from the host system. Active during power up and inactive after.
DD0 17 I/O Host Data Bus 16 bit bi-directional data bus between host and drive. Lower 8 bits used for register
and ECC byte transfers. All 16 bits used for data transfers.
DD1 15 I/O
DD2 13 I/O
DD3 11 I/O
DD4 09 I/O
DD5 07 I/O
DD6 05 I/O
DD7 03 I/O
DD8 04 I/O
DD9 06 I/O
DD10 08 I/O
DD11 10 I/O
DD12 12 I/O
DD13 14 I/O
DD14 16 I/O
DD15 18 I/O
DMARQ 21 O DMA Request This signal is used with DMACK for DMA transfers. By asserting this signal, the
drive indicates that data is ready to be transfered to and from the host.
DIOW -
STOP
23 I Host I/O Write Rising edge of Write strobe clocks data from the host data bus to a register on the
drive.
DIOR -
HDMARDY
HSTROBE
25 I Host I/O Read Read strobe enables data from a register on the drive onto the host data bus.
DMA ready during UltraDMA data in bursts.
Data strobe during UltraDMA data out bursts.
IORDY
DDMARDY
-
DSTROBE
27 O I/O Channel Ready This signal may be driven low by the drive to insert wait states into host I/O cycles.
DMA ready during UltraDMA data out bursts.
Data strobe during UltraDMA data in bursts.
CSEL 28 Cable Select Used for Master/Slave selection via cable. Requires special cabling on host system
and installation of Cable Select jumper.
DMACK - 29 I DMA Acknowledge This signal is used with DMARQ for DMA transfers. By asserting this signal, the
host is acknowledging the receipt of data or is indicating that data is available.
INTRQ 31 O Host Interrupt
Request Interrupt to the host asserted when the drive requires attention from the host.
IOCS16 32 Device 16 bit I/O Obsolete
PDIAG - 34 I/O Passed Diagnostic Output by drive when in Slave mode; Input to drive when in Master mode.
DA0 35 I Host Address Bus 3 bit binary address from the host to select a register in the drive.
DA1 33 I
DA2 36 I
CS0 - 37 I Host Chip Select 0 Chip select from the host used to access the Command Block registers in the drive.
This signal is a decode of I/O addresses 1F0 - 1F7 hex.
CS1 - 38 I Host Chip Select 1 Chip select from the host used to access the Control registers in the drive. This
signal is a decode of I/O addresses 3F6 - 3F7 hex.
DASP - 39 I/O Drive Active/Drive 1
Present Time-multiplexed, open collector output which indicates that a drive is active, or that
device 1 is present.
GND 02 N/A Ground Signal ground.
19
22
24
26
30
40
KEY 20 N/A Key Pin used for keying the interface connector.