Magnadyne M3200CD - Manual (Page 7)

7
LOU
3 2 1
REPEAT
AMS
VOLUME
POWER
INTRO
Reset Button
The radio panel or LCD display may fail to func-
tion normally due to the vehicle’s battery condi-
tion, and may require resetting the radio micro-
processor if:
• The vehicle has been “jump started” from a dead
battery condition
• The vehicle battery becomes very low and is
quick-charged
• The vehicle battery is removed and replaced
Should this condition occur, simply press and
release the RESET button on the radio panel
using the tip of a ball point pen. This will reset the
radio microprocessor to the original factory set-
tings. After pressing the RESET button you
should recheck to see if the radio functions nor-
mally. All station programming should remain,
but you will have to reset the clock. Should the
LCD display area show any abnormal error code,
please refer to the trouble shooting guide and
solution chart below.
Error Code Problem Description Possible Remedy
ERR 1 Mechanism Problem Unknown mechanical 1. Eject the disc and try another.
problem with the CD 2. Press the reset button.
mechanism. 3. Replace the unit.
ERR 2 TOC Reading Error Laser can not read the 1. Insert a different disc.
CD disc table of 2. Check disc for excessive scratches.
contents. 3. Check disc for dirt and fingerprints.
Clean disc and reinsert.
ERR 3 Error from High The temperature of the Reduce the temperature inside the vehicle
Ambient Temp. mechanism is too high and try to play a CD at a later time.
to play CDs without
damaging them.
ERR 4 Laser Focus Error Laser pickup fails to 1. Insert a different disc.
focus and read the disc. 2. Check disc for excessive scratches.
3. Check disc for dirt and fingerprints.
Clean disc and reinsert.
4. Press the reset button.
ERR 6 CD Loading Error The loading mechanism 1. Push the reset button.
is damaged. 2. Replace the unit.
ERR 7 Laser Servo Error Laser servo is not 1. Press the reset button.
functional. 2. Replace the unit.
Specialty Features
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 7