Mercury Mountaineer 2005 - Manual (Page 167)

Parking brake
Apply the parking brake whenever
the vehicle is parked. To set the
parking brake, press the parking
brake pedal down until the pedal
stops.
The BRAKE warning lamp in the
instrument cluster illuminates and
remains illuminated (when the
ignition is turned ON) until the
parking brake is released.
Always set the parking brake fully and make sure that the
gearshift is securely latched in P (Park).
The parking brake is not recommended to stop a moving vehicle.
However, if the normal brakes fail, the parking brake can be used to stop
your vehicle in an emergency. Since the parking brake applies only the
rear brakes, the vehicle’s stopping distance will increase greatly and the
handling of your vehicle will be adversely affected.
Push the pedal downward again to
release the parking brake. Driving
with the parking brake on will cause
the brakes to wear out quickly and
reduce fuel economy.
Note: If the vehicle is driven with
the parking brake applied, a chime
will sound.
TRACTION CONTROL ி (IF EQUIPPED)
Your vehicle may be equipped with a Traction Control
௢ system. This
system helps you maintain the stability and steerability of your vehicle. It
P !
BRAKE
2005 Montego (mgo)
Owners Guide (post-2002-fmt)
USA_English (fus)
Driving
167