Mitsumi electronic MAC 12 - Manual (Page 8)

7
GB
Connection to a FX PLC system
The terminal is connected to a FX PLC system
using the FX-20P-CABN cable. The cable has a
macimum length of 3 meter and the communi-
cation speed i 9600 baud.
The terminal is powered by the PLC system via
the cable. If a longer cable is required, the ter-
minal must be powered from a source other than
the PLC system.
Connection to a personal
computer
The terminal is connected to a personal compu-
ter using a SC06N adapter. The maximum cable
length is 3 meter and the communication speed
is 9600 baud.
Programming from personal
computer
You program the terminal with the PC software
installed on a personal computer. The terminal
will enter the ”Communication with MP” mode
if you keep the keys [
← ] [-] pressed during ter-
minal power up.
The PC software can also be used to make a
backup of the terminal project.
MELSEC FX
MITSUBISHI
Mac10eng Seite 7 Freitag, 5. Februar 1999 3:29 15