Marley Engineered Products 3638R - Manual (Page 7)

SHUTTER INSTALLATION
STEP 7 - Unpack Model A3024 shutter and read instructions included. Note that the first part of the shutter
instructions refer to cutting the shutter hole, which you have already done, and so they may be disregard-
ed. Follow the remaining instructions to adjust springs so that shutters open and close freely. (See Fig. 12.)
STEP 8 - Mount shutter to joists directly below fan opening with wood screws provided. Note sheet rock
must be covering center joist before shutter is installed. Again, make sure both sides of shutter open and
close freely. (See Fig. 13.) Also make sure there is clearance between spring holder on shutter and fan
blade.
STEP 9 - Fan installation is not complete. Follow wiring instructions on pages 11 and 12. Test-run fan
through all speeds.
6
FIG. 12
FIG. 13
SPRING ATTACHED
SPRING HOLDER
CONNECTOR
SPRING SHOWN
UNATTACHED
LOCKING
SCREW