McIntosh XLS360 User Manual

Page 16

Advertising
background image

16

Installation, con’t

to the Loudspeaker.

How to Mount the XCS350 Loudspeaker On the Wall
The supplied On Wall Mounting Brackets allow for four dif-
ferent mounting positions of the XCS350 Loudspeaker rela-
tive to the wall, both vertical and horizontial. Two positions
are flush mount, with the Loudspeaker close to and parallel
with the wall. The other positions are angle mount, which

places the Loudspeaker further away from the wall and al-
lows for rotation of ± 30 Degrees. Refer to figure 25.

1. Using the supplied Allen Wrench, remove the three

screws securing the Stabilizer Bar to the back of the
XCS350. Refer to figure 26. Replace the just removed
center screw with a supplied one of the same type, but

shorter length. Refer to figure 28.

Note: Retain the three removed screws and Stabilizer Bar

for possible future use.

2. Attach either the flush mount or angle mount brackets

to the rear of the Loudspeaker using the supplied
screws. Refer to figures 27, 28 and 29 for the screw

location. Also, be sure to orient the
bracket as illustrated in figure 30.

3. Determine the Loudspeaker

Mounting Location on the wall,
making sure the Mounting Bracket
will be anchored to a stud located
inside the wall.

Note: Use extreme caution to avoid

any existing electrical
wiring, plumbing, etc.,
located inside the wall.

4. Refer to figures 31 thru 34 to in-

stall the appropriate Wall Bracket
on the wall (orient the bracket as
illustrated) using the supplied
Mounting Screws. If the Flush
Mount Bracket is used, attach the
two cone shaped rubber

bumpers to the rear of the Loudspeaker, near the bot-
tom.

Note: If the wall covering material and/or thickness is

different from the illustration, the two supplied
Mounting Screws need to be replaced with screws
of the appropriate type and length.

5. Orient the Loud-

speaker to line up
with the Wall Brack-
ets and attach them

Screws - B

Screws - A

Figure 29

Figure 27

Mounting Type

Screw s - A

Screw s - B

Vertical Flush Mount

----

Remove

Vertical Angle Mount

----

Remove

Horizontal Flush Mount

Remove

----

Horizontal Angle Mount

----

Remove

XCS350 Screw Removal for Mounting

Figure 28

Location of
Mounting
Screws

Location of
Mounting
Screws

Replace with

supplied

shorter screw

Figure 26

Stabilizer Bar Screws

Stabilizer Bar

Wall
Bracket

Loudspeaker
Bracket

Locking
Screw

Wall Mounting Screws

Wall
Bracket

Loudspeaker
Bracket

Angled Wall Mounting

Hardware

Flush Wall Mounting

Hardware

Figure 25

Figure 30

Advertising
This manual is related to the following products: