Metra Electronics 99-5720 - Manual (Page 2)

1 2
Disconnect the negative battery terminal to prevent an accidental short circuit. Reach under
the driver's side dash and unclip the temperature control cable. Using Metra's 86-5618, pull
the factory radio/climate control panel from the dash. Disconnect the switch power harness,
antenna plug, radio/speaker power harnesses and vacuum hose harness.
1
Turn the integrated control panel over and disconnect the vent control harness ("A"), fan
speed control harness ("B"), and defroster harness ("C"). Unclip the main switch harness
from the side of the factory unit. (This harness connects the fan speed control harness, vent
control harness and defroster harness).
2
ALL VEHICLES 3
Turn the factory climate control dials into a vertical position and pull the dials off. (see Fig. A).
Unclip the vent control switch and remove. Remove (2) torx-head screws securing the
temperature control switch and fan speed control switch and remove. (see Fig. B). Mount the
switches to the back of the Integrated Mounting Kit with the same torx-head screws. (see Fig.
C). Holding the climate control dials in a vertical position, insert the dials onto the posts of the
mounted switches and secure. (see Fig. D)
"A"
"B"
"C"
(BACK VIEW OF INTEGRATED
CONTROL PANEL)
Fig. A
Fig. B
Fig. C
Fig. D
¾"
Fig. A
Cut and remove the shaded portion of the
sub-dash lip. (see Fig. A)
5 4
Make all wiring connections to the
Integrated Mounting Kit
and snap the
assembly into the sub-dash. Reach under
the driver's side dash and re-attach the
temperature control cable.