Marquis 9002MWD - Manual (Page 20)

Install the Handset Battery
To install the handset battery;
1. Open the battery cover as shown,
2. Insert the battery pack. Match the polarity
marks from the battery to the case (+ to
+).
3. When properly installed, the battery will
slide into position. DO NOT FORCE THE
BATTERY. Be sure the contacts are cen-
tered and the battery tab is placed into the
tab slot. Note: if the battery does not
seem to fit, turn the battery on the oppo-
site side and re-insert.
4. Replace the battery cover by inserting the
open end of the cover into the handset and
pressing the back into place.
Removing the Handset Battery and
Battery Cover
1. Insert a small screwdriver into bottom
slot. Lift the cover by lifting the screw-
driver. Do not lift the cover more that
1/2”.
2. Grip the handset tightly on the sides.
3. Depress the cover where the top portion
of the battery cover (middle of the hand-
set base) meets the handset. This will re-
lease the battery cover lock.
4. Slide the cover downward and remove.
DO NOT LIFT MORE THAN 1/2” UPWARD
Battery Placement Tab Must Be
Placed Into Housing Slot
20
3. Press Down
Center
2. Grip Here
4. Slide Downward
1. Insert small screw-
driver and lift upward
to release cover
Battery Cover
Removal