MITSUBISHI ELECTRIC FR-S520E - Manual (Page 61)

51
Chapter 2
Chapter 3
Chapter 4
Chapter 1
2. FUNCTIONS
This chapter explains the "functions" for use of this product. For simple
variable-speed operation of the inverter, the factory settings of the
parameters may be used as they are. Set the necessary parameters to
meet the load and operational specifications. Refer to the instruction
manual (basic) for the operation procedures. Always read the
instructions before using the functions.
2.1 Function (Parameter) list ................................................. 52
2.2 List of parameters classified by purpose of use ........... 65
2.3 Explanation of functions (parameters) ........................... 67
2.4 Output terminal function parameters ............................. 90
2.5 Current detection function parameters .......................... 92
2.6 Display function parameters ........................................... 94
2.7 Restart operation parameters.......................................... 96
2.8 Additional function parameters ...................................... 99
2.9 Terminal function selection parameters......................... 102
2.10 Operation selection function parameters ...................... 105
2.11 Auxiliary parameters ........................................................ 124
2.12 Maintenance parameters ................................................. 126
2.13 Brake parameters (FR-S520E-0.4K to 3.7K only) ........... 130
2.14 Calibration parameters .................................................... 131
2.14 Calibration parameters .................................................... 131
2.16 Communication parameters ............................................
135
2.17 Parameter unit (FR-PU04) setting ................................... 156
CAUTION
As the contact input terminals RL, RM, RH, STR, open collector
output terminal RUN and contact output terminals A, B, C can be
changed in functions by parameter setting, their signal names
used for the corresponding functions are used in this chapter
(with the exception of the wiring examples). Note that they are
not terminal names.
REMARKS
Parameter copy
Use of the parameter unit (FR-PU04) allows the parameter values to
be copied to another FR-S500 series inverter. After batch-reading the
parameters of the copy source inverter, you can connect the
parameter unit to the copy destination inverter and batch-write the
parameters.
For the operation procedure, refer to the instruction manual of the
parameter unit (FR-PU04).