McIntosh XRT29 - Manual (Page 10)

10
How to Prepare Hookup Cables
1. Connect a Loudspeaker Cable from the Negative (-)
Binding Post of the Amplifier to the COLUMN MID
COMmon (-) Binding Post of the Column Loudspeaker.
2. Connect a Loudspeaker Cable from the Positive (+)
Binding Post of the Amplifier to the COLUMN MID
4S (+) Binding Post of the Column Loudspeaker.
Note: The MID and HIGH COMmon (-) Binding Posts must
have a jumper installed between them. Likewise the
MID and HIGH 4S (+) Binding Posts must also have
a jumper installed between them. If the XRT29
Column is install into a wall, use the MID IN-WALL
Binding Posts instead of the Column MID Binding
Posts.
3. Tighten all of the Loudspeaker and Amplifier Binding
Posts.
The McIntosh XRT29 Loudspeaker System utilizes bind-
ing posts for speaker wire connections. Prepare the Loud-
speaker Hookup Cables that attach to the Power Amplifier
Output Terminals:
Bare wire cable ends:
Carefully remove sufficient insulation from the cable
ends, refer to figures 20, 21 & 22. If the cable is
stranded, care-
fully twist the
strands to-
gether as
tightly as pos-
sible.
Note: If desired, the twisted ends can be tinned with
solder to keep the strands together and/or attach a
spade lug.
Spade lug or prepared wire connection:
Insert the spade lug connector or prepared section of
the cable end into the terminal side access hole, and
tighten the terminal cap until the cable is firmly
clamped into the terminal so the wires cannot slip out.
Refer to figures 23, 24 & 25.
How to Connect using a single Amplifier
McIntosh Single Channel Amplifier