Motorola T2-2500 - Manual (Page 2)

INSTALL M2 ETHERNET WALLPLATE
1. Loosen existing screws by approximately 6mm
Attach bracket using the keyhole slots
Tighten screws until the brack is firnly attached
2. Connect 150mm RJ11 cable between vertical RJ11 on
m2 WallPlate and existing RJ11 jack
3. Align cover with the bracket, using a slight angle to start the
bottom hook. Apply firm pressure to snap the cover into place.
4. Install two set screws (supplied) in the pre-drilled holes
1. Loosen existing screws by approximately 6mm
Attach bracket using the keyhole slots
Tighten screws until the brack is firnly attached
2. Connect 50mm RJ11 cable between vertical RJ11 on
MC-802 WallPlate and existing RJ11 jack
3. Attach WallPlate to bracket using two 6/32 thread-forming
screws (supplied)
www.motorola.com
570343-001-00 rev A
MOTOROLA and the stylized M Logo are registered in the U.S. Patent and Trademark Office. All other product or service names are the property of their registered owners.
© Motorola, Inc, 2009
6/32 thread forming screws
6/32 thread forming screws
INSTALL MC-802 WIRELESS WALLPLATE