Magma PCI Expansion System PE6RR - Manual (Page 29)

M A G M A
Chapter 5 Chassis Maintenance
21
Cleaning the Air Filter
The chassis is equipped with an air filter that is easy to remove and
clean. To keep your chassis running at its coolest, you should clean this
filter regularly. How often the filter requires cleaning depends on
environmental conditions where your Magma Expansion chassis is
located. To clean this filter, follow these simple steps.
First, power down the chassis and then remove the four screws on the
front panel with a Phillips screwdriver.
Next, open the faceplate and remove the foam filter, located behind the
faceplate, and clean it with a solution of warm water and mild dish soap.
Finally, replace the filter and faceplate. Secure faceplate with four
Phillips screws. Tighten screws until snug. Turn on power to the
chassis.