Mellerware 35220 - Manual (Page 3)

OPERATION OF YOUR HEATER:
•
NEVER COVER THE HEATER
1. Remove the heater from all packaging and
place it in a desired location.
2. Ensure that there is a safe area between the
heater and furniture, curtains etc.
- 50cm safe area top and sides
- 120cm safe area in front
3. Unwind the power cord and plug it into the
power outlet.
4. To activate the heater, turn the knob
clockwise to the “*” position for cool air.
- I is for low power
- II is for maximum power
AUTO SAFETY SHUT-OFF:
• The heater has a built-in safety device
which will switch the heater OFF in case of
accidental overheating.
• To reset the heater, follow these steps;
1. Turn the control setting to the “O” position.
2. Unplug the heater and wait 5-10 minutes for
the unit to cool down.
3. After the unit has cooled down, plug it in and
operate normally.
4. Turn the selector switch into desired position
(Fan, Low or High).
5. Turn the thermostat switch to the desired
temperature position.
6. When you feel the room temperature is
sufficient, turn the thermostat anti-clockwise
slowly to the minimum direction until the
appliance switches off.
7. The thermostat switch will keep the desired
room temperature automatically.
8. You can also turn the thermostat switch
anti-clockwise to the minimum position or
turn it clockwise to the maximum position to
decrease or increase the temperature.
CLEANING AND MAINTENANCE:
• DO NOT IMMERSE IN WATER OR ANY
LIQUID
• Be sure to switch off the power supply and
remove the plug from the power outlet before
cleaning.
• Wait for the heater to cool down sufficiently.
• Clean the body of the heater with a damp
cloth. DO NOT ALLOW WATER INTO THE
APPLIANCE.
• DO NOT use soap or chemicals which may
damage the housing of the heater.
• Allow sufficient drying time before operating
again.
• Clean the air inlets and outlets regularly with
a vacuum cleaner.
• When the unit is not in use, we recommend
that the heater is repacked into it’s original
packaging and stored in a cool, dry place.