Macsense Connectivity Digital Wattmeter DWM-4 - Manual (Page 6)

- 6 -
___ Install the .01uf monolithic capacitors, C1 and C2.
___ Install 1/8" stereo jack.
___ Unwrap the enclosure. Install the SO-239 connectors. Put one #4 screw in hole and place two
nuts on the screw. Repeat with the other three screws. Do not tighten them at this time.
___ Place the PC board onto the SO-239s. Align the 1/8” jack with the hole in the enclosure. Once
this is in place, you may tighten the nuts that are underneath the PC board. You do this by
pressing the board down on the nuts while turning the screw. Repeat with the other three screws.
___ Install the remaining four nuts on top of the PC board and tighten.
___ Solder the SO-239s to the PC board.
You are now finished with the VHF/UHF Remote Sensor.