Microstar MS-6547 (v1.X) ATX Mainboard G52-MA00514 - Manual (Page 14)

Chapter 2
2-2
Open Lever
Dot / Cut edge
Sliding
Plate
Close
Lever
Central Processing Unit: CPU
The mainboard supports Intel ® Pentium ® 4 processor in the 478 pin
package. The mainboard uses a CPU socket called PGA478 for easy CPU
installation. When you are installing the CPU, make sure the CPU has a heat
sink and a cooling fan attached on the top to prevent overheating. If you do not
find the heat sink and cooling fan, contact your dealer to purchase and install
them before turning on the computer.
1. Pull the lever sideways away
from the socket. Then, raise
the lever up to a 90-degree
angle.
2. Look for the dot/cut edge. The
dot/cut edge should point to-
wards the lever pivot. The
CPU will only fit in the correct
orientation.
3. Hold the CPU down firmly, and
then close the lever to
complete the installation.
CPU Installation Procedures
Overheating will seriously damage the CPU and system,
always make sure the cooling fan can work properly to
protect the CPU from overheating.
WARNING!
Kap2_6547v1.1.P65 05.02.02, 09:36 2