Marshall electronic AUDIOSTATE LR150 - Manual (Page 6)

5
LR150 Top Panel Features (page38)
AUDIO STATE LR150
ENGLISH
Channel 1 & Channel 2
1. & 5. Low
Controls the low frequencies on Channel 1 and
Channel 2 respectively.
2. & 6. High
Controls the high frequencies on Channel 1 and
Channel 2 respectively.
3. & 7. Effect
When using the in-built reverb on the LR150 this
control will adjust the amount of reverb on
Channel 1 and Channel 2 respectively. When
using an external effects processor this will
control the amount of effected signal, as it
dictates the amount of signal to the Effects Send
(item 10) on the rear panel.
Note - this will be effected by the Effect Return
control (item 19) and the Master Reverb control
(item 20).
4. & 8.Volume
Controls individual volume level for channel 1
and 2 respectively. Overall volume will be
governed by the Master Volume control (item
21).
Channel 3 & Channel 4
9. & 14. Low
Controls the low frequencies on Channel 3 and
Channel 4 respectively.
10. & 15. Mid
Controls the mid frequencies on Channel 3 and
Channel 4 respectively.
11. & 16. High
Controls the high frequencies on Channel 3 and
Channel 4 respectively.
12. & 17. Effect
When using the in-built reverb on the LR150 this
control will adjust the amount of reverb on
Channel 3 and Channel 4 respectively. When
using an external effects processor this control
will control the amount of effected signal, as it
dictates the amount of signal to the Effects Send
(item 10) on the rear panel.
Note - this will be effected by the Effect Return
control (item 19) and the Master Reverb control
(item 20).
13. & 18. Volume
Controls individual volume level for channel 3
and 4 respectively. Overall volume will be
governed by the Master Volume control (item
21).
Master Section
19. Effect Return
This is the master Effects Return and is an effects
mix control, allowing you to decide when using
an external effects processor how much of your
overall sound will be effected. Further control is
given by the individual Effect control which
features on each channel.
20. Master Reverb
The LR150 comes complete with an in-built
spring reverb. The overall reverb level for the
combo is set here, with independent controls
featuring on each channel allowing you to set
independent levels for each channel.
21. Master Volume
The overall volume of the combo is set here. As
with effects and reverb, there is an independent
control on each channel allowing you to set
independent volume levels for each channel.
This will not however affect the level of the Line
Out Jack on the rear panel (item 12).
22. LED
Indicates operating status of combo.