Metrologic Instruments FOCUSE IS1650 - Manual (Page 25)

21
S
CANNER
O
PERATION
M
ODES OF
O
PERATION
*
Presentation Mode, Fixed-Mount or In-Stand (Default)
1. The IR detects an object in the IR activation range and the scanner’s
light output automatically starts to flash as it attempts to scan the bar
code.
2. The scanner continuously attempts to scan the bar code until either it
succeeds or the bar code is removed from the scanner’s field of view.
3. When scanner successfully reads the bar code it will beep once, the
white LED will flash and the decoded data will be transmitted to the
host.
Single Trigger Mode, Out-of-Stand *
The IS1650 can switch into different
modes of operation using the
MetroSet2 Software or Area Imaging
Supplemental Guide (00-02281).
1. The IR detects an object in the IR
activation range and automatically
turns on linear illumination.
2. Aim the scanner’s line of light
over the bar code.
3. Press the trigger to initiate scanning.
The scanner’s light output will start to
flash as it attempts to scan the
bar code.
If the trigger is released the
scanner will stop trying to scan.
4. When scanner successfully reads the
bar code it will beep once, the white
LED will flash and the decoded data
will be transmitted to the host.
* For additional configurable modes of operation, please refer to the Area
Imaging Supplemental Configuration Guide (
MLPN
00-02281).
Figure 15. Single Trigger Mode,
Out-of-Stand