McIntosh M85 - Manual (Page 10)

10
How to Connect with Optional Tuner Module
How to Connect with Optional Tuner Module
1. Connect a data cable from the TUNER 1 DATA IN jack
to the TUNER DATA PORT of a McIntosh Multizone
Control Center.
2. Connect a data cable from the TUNER 2 DATA IN jack
to the LOCAL ZONE 1 AUX IN DATA PORT of a
McIntosh Multizone Control Center.
3. Connect a power control cable from the POWER CON-
TROL IN jack to the POWER CONTROL OUT of a
McIntosh Multizone Control Center.
4. Connect shielded cables from the TUNER 1 FIXED
OUTPUTS to the TUNER INPUTS of a McIntosh
Multizone Control Center.
Note: An optional connection would be to use the TUNER 1
VARIABLE OUTPUTS.
5. Connect shielded cables from the TUNER 2 FIXED
To AC Outlet
OUTPUTS to the LOCAL ZONE 1 AUX IN AUDIO
Jacks of a McIntosh Multizone Control Center.
Note: An optional connection would be to use the TUNER 2
VARIABLE OUTPUTS.
6. Connect the FM Antenna(s) or Cable (from the Cable
Company) to the MR85 Tuner 75W (Ohm) FM
ANTenna connector for both Tuner 1 and 2.
Note: If the same FM Antenna or Cable (from the Cable
Company) is used for both Tuner 1 and 2, a suitable coaxial
splitter must be utilized.
7. Connect with the supplied cables, from the 5 Pin Socket
of the McIntosh RAA1 Remote AM Antenna(s) to the
MR85 Tuner AM ANT DIN socket(s) for both Tuner 1
and 2.
8. Plug the MR85 AC Power Cord into a live AC Outlet.