Operation, Installing or removing socket, Standard bolt – Makita 6917FD User Manual
Page 8
8
Installing or removing socket
To install the socket, push it onto the anvil of the tool until it
locks into place.
To remove the socket, simply pull it off.
OPERATION
The proper fastening torque may differ depending upon the
kind or size of the bolt, the material of the workpiece to be
fastened, etc. The relation between fastening torque and fas-
tening time is shown in the figures.
Hold the tool firmly and place the socket over the bolt or nut.
Turn the tool on and fasten for the proper fastening time.
NOTE:
•
Never use the tool to tighten bolts or nuts for a fastening
torque greater than the tool-fastening capacity. Such
usage may result in damage of the anvil. This tool is
intended for assembly and disassembly automotive
components and is provided with 9.5 mm (3/8”) anvil.
•
When fastening screw M8 (5/16”) or smaller, carefully
adjust pressure on the switch trigger so that the screw is
not damaged.
•
Hold the tool pointed straight at the bolt or nut.
•
Excessive fastening torque may damage the bolt/nut or
socket. Before starting your job, always perform a test
operation to determine the proper fastening time for your
bolt or nut. Especially for the bolt smaller than M8 (5/
16”), perform the above test operation to prevent the
trouble on socket or bolt, etc.
•
If the tool is operated continuously until the battery
cartridge has discharged, allow the tool to rest for 15
minutes before proceeding with a fresh battery.
The fastening torque is affected by a wide variety of factors
including the following. After fastening, always check the
torque with a torque wrench.
1. Socket
2. Anvil
1
2
003920
N m
80
100
60
40
20
0
1.0
2.0
3.0
(S)
M14
M12
M10
M10
M12
M14
F
astening torque
Fastening time
Proper f
astening torque
.
(ft lbs)
.
(72)
(58)
(43)
(29)
(14)
(9/16")
(9/16")
(1/2")
(1/2")
(3/8")
(3/8")
Standard bolt
002359
N.m
(ft.lbs)
80
(58)
100
(72)
120
(87)
60
(43)
40
(29)
20
(14)
0
1.0
2.0
3.0
4.0
5.0 (S)
M8 (5/16”)
M10 (3/8”)
M10 (3/8”)
M8 (5/16”)
Fastening time
F
astening torque
Proper f
astening torque
High tensile bolt
003921