Magnadyne M1-NAV - Manual (Page 35)

35
Feature Locations
RGB VIDEO RESET
PWR
SD
1 2 3 4
1. RGB/Video Switch: Leave the switch in the RGB
mode. Video mode has no function.
2. Reset Button: The navigation system may fail to
function normally due to the vehicle’s battery
condition, and could require resetting the navi-
gation microprocessor if:
• The vehicle has been “jump started” from a
dead battery condition.
• The vehicle battery becomes very low and is
quick-charged.
• The vehicle battery is removed and replaced.
Should any of these conditions occur, simply
press and release the RESET button using the
tip of a ball point pen. This will reset the micro-
processor to the original factory settings. After
pressing the RESET button, you should recheck
to see if the navigation system functions nor-
mally.
3. Power Indicator: Indicates when the navigation
system has power.
4. SD Card: The navigation system comes pre-
loaded with the navigation SD card. Do not
remove the memory card. This could result in
loss of data.
M1-NAV 8/4/08 1:23 PM Page 35