Morphy Richards KT43530 - Manual (Page 4)

BEFORE FIRST
USE
Before using the appliance
for the first time, fill with
water, boil and pour away.
OPERATING THE
APPLIANCE
Filling the kettle
1 Wherever possible fill
through the spout, as this
helps to free the filter from
limescale build-up.
• The integrated water level
indicator allows you to
easily see the amount of
water in the kettle.
• Always ensure that the level
of water in the kettle is filled
to at least the minimum
level shown on the water
gauge.
• Boil only as much water as
you need as this saves
electricity.
Corded models
2 Push the mains lead
connector firmly into the
kettle socket ‰.
Cordless models
2 Take the kettle to the base
unit, hold the kettle level
and then gently but firmly,
push the rear of the kettle
down to engage it with the
base unit connector.
3 Plug in and switch on at
the wall socket.
4 Switch the kettle on. The
‘power on’ neon will light
up.
5 When the water boils the
kettle will switch off
automatically.
Corded models
6 Pull the mains lead
connector out of the kettle.
Cordless models
6 Lift the kettle from the base
unit by the handle ensuring
you hold the kettle level.
• To re-boil, switch to ON
again. If the kettle has just
switched off wait a minute
or so before switching it
back on again.
• If you do not put in enough
water, or switch on the
kettle when it is empty, the
safety cut-out will switch
off the power automatically.
If this happens, refill and
wait a few minutes for the
element to cool, then use
as normal.
Filter removal
1 Open the lid.
2 Lift the filter upwards from
its location.
3 To refit the filter, slot it into
the side wall guides and
press down firmly. Ensure
the filter is correctly located
into the central guide.
WARNING: Unless the
filter is fitted correctly,
the kettle lid may not
close and lock securely
and the kettle may not
switch off automatically.
4 UK Helpline 0844 871 0954 Replacement Parts 0844 873 0720 Ireland Helpline 1800 409 119
43530 rev3:KT4530 REV2 23/10/2009 13:58 Page 6