Merco Savory ST-1 - Manual (Page 5)

ST-1 Mini-Conveyor Toaster Operations Manual 5
OPERATION INSTRUCTIONS (CONT’D)
7. When toaster is not in constant use, set switch to the “STAND-BY” position.
When returning to “Full” Power position for normal operation mode, allow a 5-minute warm-up period
before resuming toasting operation. (If desired, return to Full power and make a slight reduction in the
conveyor speed. This slower speed allows you to start toasting immediately while unit is returning to full
power. After approximately 5 minutes, return conveyor speed to original setting.)
CLEANING INSTRUCTIONS
The ST-1 is designed for easy cleaning. The stainless steel outer surfaces need nothing more than a daily wiping
with a soft, damp cloth. The reflector tray and receiving tray should be removed daily and wiped with a soft, damp
cloth to remove any crumb build-up. These components may be washed in hot sudsy water to remove any
stubborn crumb build-up and should be kept clean to help promote optimum toaster performance. The conveyor
belt should be cleaned with a damp cloth or a stiff bristled brush (non-metal) using a side-to-side motion.
! CAUTION: Unplug toaster and allow to cool before cleaning.
! CAUTION:
When switching to this position, always come to a full stop at the “Off” position first to
avoid damage to the switch.
! CAUTION:
Do not use abrasive cleaners on any part of this toaster as this will cause damage to
the toaster’s finish.
! WARNING:
Care must be taken to prevent water or cleaning compounds from getting on the
internal parts, especially the switches on the control panel.
! WARNING:
Do not immerse this toaster in water or spray water directly onto any part of this
toaster as this will cause damage to the internal workings, shorten lifespan and may
cause personal injury.