Magnadyne Extreme Series X4 - Manual (Page 13)

If your transmitters have been programmed to a second Marksman security system, follow the
steps below:
For LCD Remote Control Transmitter
Second Vehicle Operation:
1. Press and hold and buttons at the same time until one long beep is
heard. Programming Mode has now been entered.
Note: No action for five seconds will generate two long beeps indicating the
Programming Mode has been exited.
2. Within 5 seconds, press and hold the button until two beeps are heard and
the icon is displayed on the LCD screen. The transmitter is now in 2nd car
operation mode.
3. With the is displayed, press any button on the transmitter to control the second vehicle’s
security system, alarm function or remote short function.
Note: Button functions are the same for the second vehicle as they are for the first vehicle.
Return to First Car Operation
1. Press and hold and buttons at the same time until one long beep is heard.
Programming Mode has now been entered.
Note: No action for five seconds will generate two long beeps indicating the
Programming Mode has been exited.
2. Within 5 seconds, press and hold the button until one beep is heard and the
icon is not displayed on the LCD screen indicating first vehicle operation.
For 1-Way Remote Transmitter
Press the II button on the 1-way transmitter, the LED will light up for approximately 2 seconds.
During that time, any single command can be sent to a second vehicle security system.
13
How to Control a Second Marksman Security System
II- Arm / Lock
II- Disarm / Unlock
II- Trunk Release
II- Car Finder