Motorola DCT2000 - Manual (Page 19)

1 5
USING THE REMOTE CON TROL
+
+
Installing Batteries
Before you can use the remote control, you must install two AA (1.5-volt)
alkaline batteries:
1
Slide open the battery door on the back of the remote control.
2
Insert the batteries in the direction indicated on the inside of the
battery compartment.
Batteries installed incorrectly can cause battery leakage and corrosion that
will damage the remote control.
3 Slide the battery door closed until it snaps into place.
Point the remote control at the DCT 2000, and then press POWER . If the
DCT 2000 does not turn on, check the orientation of the batteries or
replace with new batteries.
Your remote control may be different from the one illustrated here. Refer to the
remote control instruction guide for details on battery installation.