Mercury Marine 90-830296005 - Manual (Page 4)

PROPELLER INSTALLATION INSTRUCTIONS
Page 4 / 7 90-830296005 FEBRUARY 2010
3. Install the aft washer onto the drive sleeve assembly and lightly tap the drive sleeve assembly into the propeller. The aft
washer will contact the propeller when the drive sleeve assembly is properly seated.
a - Aft washer
IMPORTANT: The Flo‑Torq Reflex drive hub requires the use of the thrust washer that is included with the drive hub kit.
Mercury Outboard Application
1. Install the thrust washer onto the propeller shaft.
43671
2. Install the propeller.
3. Install the aft washer, the tab washer, and secure with the propeller nut included with the kit. Tighten the nut to the specified
torque. Bend the tabs on the tab washer onto the nut.
IMPORTANT: The Flo‑Torq Reflex drive hub requires the use of the propeller nut included with the drive hub kit. The use
of a propeller nut that was not included with the Flo‑Torq Reflex drive hub kit will result with the nylon portion of the locknut
not fully engaging the propeller shaft threads.
a - Thrust washer (Mercury/Yamaha)
b - Propeller
c - Aft washer
d - Tab washer
e - Nut
4. Rotate the propeller to verify interference or binding does not exist between the gear housing and the propeller.
Description Nm lb‑in. lb‑ft
Nut 74.6 55
NOTE: A small amount of rotation play and forward aft play is normal.
Honda and Yamaha Outboard Application
1. Install the correct thrust washer onto the propeller shaft.
a - Yamaha application
b - Honda application
2. Install the propeller.
a
43668
a
b
c
d
e
43652
a
b
43672