Muratec MFX-2830 - Manual (Page 443)

In This Case... ● Maintenance and Troubleshooting
Getting
Started
COPY
Chapter1
COPY
Chapter2
COPY
Chapter3
FAX
Chapter1
FAX
Chapter2
FAX
Chapter3
FAX
Chapter4
Common
Settings
In This
Case...
Appendix
5-23
Cleaning document feeder roller
ADF cover
release lever (A1)
1
Lift the ADF cover release lever
(A1) to open the ADF cover.
2
Clean the document feeder roller.
(1) Dip a soft cloth in water and
wring it out thoroughly before
wiping the roller.
Inside cover
(2) Open the inside cover (A2).
Dip a soft cloth in water and
wring it out thoroughly before
wiping the roller.
(2)
(1)
3
Close the ADF cover.
(1) Close the inside cover.
(2) Close the ADF cover.
A dirty document feeder roller will not only make the document dirty, but also cause black lines
or other unwanted markings printed in copies or the received document by receiving party. It can
also cause document jams.
· Wipe down the whole roller,
turning it with one hand. (Some
rollers do not turn.)
· When the dirt is heavy, wipe
them with a cloth dipped in a
small quantity of a mild cleaning
solution, and then wipe them
again with a cloth dipped in wa-
ter and thoroughly wrung out.
Note
· Wipe down the whole roller,
turning it with one hand.
· When the dirt is heavy, wipe
them with a cloth dipped in
a small quantity of a mild
cleaning solution, and then
wipe them again with a
cloth dipped in water and
thoroughly wrung out.
Note
Maintenance
Do not use benzene or thinner as cleaning agents which could damage plastic and paint.
Important