Mitsumi electronic 6402 - Manual (Page 9)

5
The Test feature allows you to test the lights on your telephone and the
display, if the telephone has one.
To test the lights and display on the telephone
1. While on-hook, press and hold down .
The lights go on steadily, and, if your telephone has a display, all the
display segments fill in.
2. To end test, release .
Lights return to normal operation.
Note: If the display or the lights do not respond during the test, notify your
system manager.
The Transfer feature allows you to transfer a call from your telephone to
another extension or outside number.
To send the present call to another extension
1. Press .
2. Dial the number to which the call is to be transferred.
3. Remain on the line and announce the call. (If the line is busy or if there
is no answer, you can return to the held call by pressing and then
releasing the switchhook.)
4. Press again to complete the transfer.
5. Hang up.
Note: If your telephone is connected to DEFINITY Release 6.3.2 or a later
release, your administrator may have chosen Transfer-on-Hang-up. In
this case, you can transfer a call by pressing
, dialing the
number to which the call is to be transferred, and then hanging up.
To cancel an attempted transfer, press and release the switchhook or
press
and then the dial pad key on which the Drop feature is
administered.
Getting Messages
Your Message light goes on when a caller has left a message for you.
For directions on retrieving your messages, see your system manager.
Test
Transfer
Message
Trnsfr
Trnsfr
Trnsfr
Trnsfr
Trnsfr
Feature