M-AUDIO KeyStudio 25 - Manual (Page 24)

|
23 Session KeyStudio 25 User Guide
The procedure described above will toggle the value each time you press the button or footswitch. It is also possible to configure the
control so that it sends one value when it is pressed, and another value when released. To do this:
1. Press the ADVANCED FUNCTION button and push the footswitch or button you wish to modify.
2. Press the CTRL ASGN key.
3. Enter 146 using the numerical data entry keys or DEC/INC buttons. This sets the control for MIDI CC (On/Off) mode.
4. Press ENTER to confirm.
5. Press the ADVANCED FUNCTION button again, followed by the DATA 1 key.
6. Enter the number of the MIDI CC you want the button to send out.
7. Press the ENTER key to confirm.
8. Assign the two toggle values for “control press” (DATA 3) and “control release” (DATA 2) using the procedure described
above.
Assigning MIDI Machine Control (MMC) Commands to a Button
1. Press the ADVANCED FUNCTION button and push the button you wish to modify.
2. Press the CTRL ASGN key.
3. Enter “149” using the numerical data entry keys to indicate that you would like to assign an MMC command to your
selected button (see Appendix B for a complete list of MIDI CC numbers and their corresponding commands).
4. Press the ENTER key to confirm
5. Press the ADVANCED FUNCTION button, then the CHAN
ASGN key.
6. Enter “127” using the numerical keypad. This ensures that the
message is sent to all device ID numbers.
7. Press the ENTER key to confirm.
8. Press the ADVANCED FUNCTION button, then the DATA 2 key.
9. Enter a number from the chart on the right to assign the
corresponding MMC message to your selected button.
Number MMC Command
01 STOP
02 PLAY
03 DEFERRED PLAY
04 FAST FORWARD
05 REWIND
06 RECORD STROBE
07 RECORD EXIT
08 RECORD PAUSE
09 PAUSE
10 EJECT
11 CHASE
12 COMMAND ERROR RESET
13 MMC RESET