Magnadyne M8a - Manual (Page 8)

8
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to give
your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all
alarm functions and remote start functions are bypassed. However, the remote panic feature and
remote door locks will remain operational. To use the valet mode, the system must be disarmed
either by using you remote transmitter, or by operating the manual override sequence.
Enter Valet Mode:
1. From the disarmed mode, turn the ignition to the “ON” position.
2. Push and hold the valet switch for 2 seconds until the LED turns on. The LED will remain on
as long as the system is in “Valet Mode”.
Exit Valet Mode:
1. To return to normal operation, turn ignition “ON”.
2. Push and hold valet switch for 2 seconds. The LED will turn off indicating the system is
exiting the valet mode.
Actions of the 2-Way LED Remote Control Transceiver
LED Melody Sound
Remote Door Lock
Zz
z
LED turns on for 2 seconds 1 Chirp
Remote Door Unlock
Zz
z
LED turns on for 2 seconds 2 Chirps
When armed, press the button to active car locator function. The siren will then chirp 6 times and
the parking lights will flash 12 times.
Actions of the 2-Way LED Remote Control Transceiver Melody Sound
Melody Sound
Car Locator One “Activate” Melody Sound
Valet Mode (System in Disarm or Valet Mode)
Car Locator
The override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to the “ON” position (alarm will sound).
2. Within 10 seconds push and release the valet switch. The alarm will stop sounding and enter
the disarm mode. You can now start and operate the vehicle normally.
Disarming without a Transmitter