MicroNet Technology SP218D - Manual (Page 11)

2.5 Installation Steps
Follow the steps below to setup the hardware:
y Plug the 3-in-1 end of the KVM cable to the PC. Connect the HDB-15
connector to PC’s VGA port. Attached the PS/2 connector for both
mouse and keyboard to PC’s PS/2 ports.
y For PC with USB port, use a PS/2 to USB converter to switch
between interfaces and connect via PC’s USB slot.
y Then connect the other end of the 3-in-1 cable with only a single
HDB-15 connector to the PC port on the rear of KVM.
y Connecting multiple KVM together, please use a daisy chain cable
(sold separately) to connect via the Daisy Chain port and Local
Console’s VGA port.
y Double check whether all cables/connectors are properly connected.
Plug the power supply to the KVM switch and plug the AC power plug
7