Motorola MBP35BL - Manual (Page 10)

10 Getting started
2. Press and hold
p
to switch ON the parent unit. The power LED
will light up in green.
3. Press and hold
p
to switch OFF the parent unit.
NOTE
Once the baby and parent units are switched on, the display on the parent
unit will show the video captured by the baby unit. When the VOX mode
is on, the screen will turn off after a few seconds if the sound near the
baby unit drops below the Voice Activation threshold level of the unit.
When there is no connection or out of range, the
icon on the LCD
display will flash and the parent unit will beep continuously. Move the
parent unit closer to the baby unit until the link is re-established.
2.5 Registration
The Baby monitor is pre-registered to your Parent Unit. You do not need
to register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the
procedure below:
1. Switch off the Baby Unit
2. Press and hold the
m
button on the Parent Unit until
appears on the display screen.
3. Then press the
m
button to confirm the selection and enter the
registration mode. ..... will appear on the screen for up to 15
seconds.
4. Switch the Baby Unit ON to enter the registration mode. The power
LED on the Baby Unit flashes quickly for approximately 3 seconds.
The registration is completed when .....OK appears and then the
video captured by Baby Unit’s camera appears on the display screen of
the Parent Unit.
If the registration fails then
.....X appears and then both the Parent
and Baby Unit return to normal mode.
NOTE
If a particular Baby Unit had been registered already, registering this
current Baby Unit again will over-write the old registration.