Murphy PVS-5 - Manual (Page 2)

Warranty - A limited warranty on materials and workmanship is given with this FW Murphy product. A copy of the warranty
may be viewed or printed by going to www.fwmurphy.com/support/warranty.htm
Mounting
The PVS-5 can be mounted under or behind the dash using cable ties or screws. Refer to the following installation
examples when mounting the power supply device.
CAUTION: The mating connector does not
have a water tight seal. If the device is
mounted in a location exposed to the risk of
moisture, then the device should be mounted
in an orientation that will protect the
connector from water seepage (connector
facing down) or sealed against moisture.
Mounted using two #8 screws Mounted using cable ties through
each of the mounting holes.
Mounted using one cable tie
across the device.
Wiring Diagram
The pin out information for the 4 pin connector is shown below.
Mating Connector – Tyco Electronics AMP Mini
Universal Mate-N-Lok Plug Housing 4 Position,
AMP P/N 172338-1
Murphy P/N 00-00-6935
Accessories
Model Wiring harness Rendering Wiring Harness Designation Schematic Part Number
PVWM-J
PVM Gage Harness
78-00-0479
78-00-0490
78-00-0503