Morphy Richards Series 2000 - Manual (Page 4)

4
G Ge en ne erra all u us se e
1 Lift up the hinged reservoir lid.
2 Fill the glass jug with
the required amount of cold water and pour
into the reservoir. Both the jug and water
level indicator are marked in cups. Do not
exceed the maximum level.
3 Spoon the required amount of ground filter
coffee into the mesh filter spreading it evenly.
We suggest one level dessert spoon for every
1
1/2 cups. Ensure the filter is sitting properly in
the filter holder.
4 Close the reservoir lid.
5 Select the strength of coffee required using
the strength selector on the reservoir lid.
6 Slide the jug into the coffee maker ensuring it
sits correctly on the hot plate. The jug lid
must be in place during the brewing
process, otherwise the non-drip valve
will not open, causing the filter to flood.
7 Plug the coffee maker in at the wall socket and
switch the coffee maker ON. The switch will
light up to show the coffee maker is working.
8 Hot water will start to flow through the coffee
grounds and into the glass jug as coffee.
9 When the coffee has been made, serve as
required. The anti-drip valve will prevent any
remaining coffee dripping onto the hot plate.
Ensure that the jug is replaced on the hotplate
after serving. While the coffee maker is
switched ON the hot plate will keep the coffee
warm.
10 Switch off the coffee maker when the jug is
empty or the coffee is no longer required.
WARNING THE COFFEE MAKER AND
HOT PLATE ARE HOT AND REMAIN
HOT FOR SOME TIME AFTER
SWITCHING OFF.
11 Remove the permanent mesh filter using its
handle and empty the used coffee grounds.
Wash the filter immediately and dry
thoroughly. NOTE: THE MESH WILL
BECOME DISCOLOURED AFTER A WHILE
DUE TO THE STAINING EFFECT OF
COFFEE.
R Re effiilllliin ng g
Switch off the coffee maker and allow
3 minutes to cool before refilling with cold water.
4