Description, Power supply, Ups (uninterruptible power supply) – Micro Technic MICRONIX PC/104 PV-5120 User Manual

Page 2: Battery charger, Ssd (solid state disk)

Advertising
background image

Users Manual & Installation Guide

PV- series:

Power supply module with UPS and SSD Flash

Page 2 of 8

Description

Micronix PV-5124 is a PC/104 Power Supply with 1.76/3.84 MB Flash SSD which provides a

convenient way to supply both power and solid state disk capacity to PC/104 bus products. The flash

SSD emulates a standard FDD, a complete system can thus be built from just one Micronix PV-5124

and one PC/104 CPU.

By connecting an external battery, an integrated UPS-function will provide a CPU controlled /

automatic shut down procedure of the operating system. An integrated battery charger will insure

maintenance of the battery during operation.

Power Supply

PV-5124 has a high efficiency DC to DC converter with 30 Watt output capability.

The Power Supply will supply +5V, +12V and –12V to the PC/104 bus.

UPS (Uninterruptible Power Supply)

Micronix PV-5124 has an integrated battery charger and built-in UPS function with interrupt alarm

outputs. It also features a CPU controlled / automatic shutdown facility for battery discharge

protection. The automatic shut down procedure is initiated when both “Mains failure” and “Low

battery” have been detected for 120 seconds. At the end of this “shut down time” +5V will be

removed from the system. “Low battery” occurs when Vbat goes below 10.8V. The CPU controlled

shut down is initiated by a user program.

See “Typical discharge/charge cycle” on page 8.

Battery charger

The integrated battery charger will deliver a constant current(400mA) to the battery as long as the

battery voltage hasn’t reached 13.8V. After reaching this point, the charger will act as constant

voltage source(13.5V).

See “Typical discharge/charge cycle” on page 8.

SSD (Solid State Disk)

The SSD can emulate a diskette drive as either drive A or B with up to 3.84 MB of capacity. The

SSD holds factory installed firmware, including a set-up program where you can configure the SSD

during boot, and the diskette data itself.

The SSD is most useful with DOS, where you both can have a complete operating system and an

application on the SSD

.

Further technical information concerning:

Flashdisk

,

Set-up program

and programming

can be found

at our web site:

http://www.micro-technic.com/pv5124

Advertising
This manual is related to the following products: