Marshall electronic OPTIONAL ACCESSORIES MC-0105 - Manual (Page 2)

Switch Settings and Indicators 7 7
Operational Setup
1. Unpack the MC-0105, and accompanying V-PS6-1.2A power supply and physically inspect for any damage that may have occurred
during shipping. Also verify there is a small package with mounting accessories. Should there be any damage, immediately contact
Marshall Electronics at 800-800-6608. If you are not located within the continental united states call +1 310-333-0606.
2. Install in your desired location. If wall mounting is required, attach the mounting brackets by removing the Phillips head screws on
the sides, closest to the rear of the unit. (See below) Only one screw per side should be removed. Use the same screw to attach the
bracket with the flange facing away from the side and parallel to the front of the MC-0105 metal case. The flange has two holes. For
desktop use, apply the supplied rubber pads.
3. Connect required cables for signal input and output.
All BNC connectors should be rated for 75Ω .
4. Plug the V-PS6-1.2A power supply into the A.C. source
5. Attach twist lock power connection from V-PS6-1.2A
power supply to the back of the unit.
6. Turn on the MC-0105 by depressing the power
switch located on the front of the unit.
7 6
Input Connectors
S-Video In
4 Pin Din (Fe-
male)
Pin1 - GND
Pin2 - GND
Pin3 – Y in
Pin4 – C in
VGA-In
DB HD-15 Female
Connector Input
Pin-1 Red In
Pin-2 Green In
Pin-3 Blue In
Pin-4
Pin-5
Pin-6 Ground
Pin-7 Ground
Pin-8 Ground
Pin-9
Pin-10
Pin-11
Pin-12
Pin-13 VS In
Pin-14 HS In
Pin-15 VGA-Out
DB HD-15 Female
Connector Output
Pin-1 Red Out
Pin-2 Green Out
Pin-3 Blue Out
Pin-4
Pin-5
Pin-6 Ground
Pin-7 Ground
Pin-8 Ground
Pin-9
Pin-10
Pin-11
Pin-12
Pin-13 VS Out
Pin-14 HS Out
Pin-15 6 VDC from
V-PS6-1.2A power
supply
Left Pin - Pos
Right Pin- Neg
Note: VGA inputs signals of any format will be output as the same format when VGA source is selected.
For best operation a multi-sync monitor should be used.
Note: NTSC signals are converted to 480x640 VGA resolution output. PAL signals are converted to 576x640 VGA resolution output.
7 8
Input Selection
Indicators
Power On/Off switch with System indicator.
Illuminates Red when Power is connected.
Illuminates Green when the MC-0105 is switched on
Input Selection Toggle Switch
Toggles input source to output selection
Analog
Video In
BNC
1910 East Maple Ave. El Segundo, CA 90245 • Tel.: 800-800-6608 • Fax:310-333-0688 • www.LCDRacks.com • Email: [email protected]