Engine disassembly – MTD AC3 User Manual
Page 58
AC3 Series of Engines
54
Engine disassembly
NOTE: There are a few different paths that can be
followed when disassembling an engine.
This chapter will cover the removal of com-
ponents in one order, but it is written so that
the technician can go to the component
being removed.
1.
Drain the oil by following the steps described in
Chapter 2: Maintenance.
2.
Remove the Clutch by following the procedures
described in Chapter 7: Clutch and Drive Shaft.
3.
Remove the starter following the steps described in
Chapter 6: Starter.
4.
Remove the three screws that hold the engine cover
to the engine using a T-25 torx driver.
See Figure 8.1.
5.
Remove the three screws that secure the muffler to
the cylinder head. See Figure 8.2.
6.
Remove the air filter cover.
7.
Remove the two screws in the air filter housing.
See Figure 8.3.
Figure 8.1
Remove these screws
Figure 8.2
Muffler screws
Figure 8.3
Air filter housing screws
Breather/PCV