Musical Fidelity AMS35I - Manual (Page 11)

AMS35i AMPLIFIER SPECIFICATIONS
Issue 2
Page 11 of 12
Output: Power 35 Watts per channel into 8 Ohms (15.5dBW),
Voltage 17 Volts RMS 20Hz to 20 kHz
Voltage 47 Volts Peak-to-peak
Current peak-to-peak 20 Amps
Damping factor 130
Output devices 2 pairs per channel
Balanced Line input:
THD+N < 0.014% unwtd, 20Hz to 20 kHz
Signal / noise ratio > 96dB ‘A’-weighted
Input impedance 40k Ohms
Frequency response 10Hz to 50 kHz, +0, -1dB
Connections:
Line level inputs 1 pairs line level XLR (balanced) connectors
4 pairs line level RCA connectors
Line level outputs 1 pair line level RCA connectors, constant level TAPE outputs
1 pair line level RCA connectors, preamp outputs for e.g. biamping
Speaker outputs 2 pairs 4mm banana plug/binding posts
Power requirement:
Mains voltages: 115/230VAC 50/60Hz (factory pre-set)
100VAC 50/60Hz (alternative)
Consumption: 330 Watts continuous
Weight:
28.3kg 62⅓lbs unit only, unboxed
33kg 72⅔ lbs in shipping carton
Dimensions: 483mm,
19” wide
148mm, 5⅞” high including feet
475mm, 18¾” deep (front to back) including terminals
Standard accessories:
IEC type mains lead (10-Amp type),
AMS35i remote control
Varta CR2450 Li-Mn battery
Musical Fidelity reserves the right to make
improvements which may result in specification or
feature changes without notice.