Updating the firmware, Resetting the unit – Memorex 8564 User Manual
Page 39
38
WARNING! Do not update the firmware unless you are experiencing problems with
your digital audio device. Incorrect or faulty firmware installation will cause the player
to stop functioning.
1. Download the updated firmware at www.memorexelectronics.com.
2. Unzip the file, then double click setup.exe in the Desktop folder to install the
software to your computer.
3. Connect the player to the computer using the supplied USB cable and the
installation screen will appear. (If the installation screen does not appear, unplug
the USB cable and turn off the unit). Connect to the computer again and press and
hold the Power On/Off/Stop button until the installation screen appears.
4. Follow the on-screen instructions to install the driver.
5. When finished, click START and locate the newly installed software “Stop Sime II”
and select “Firmware Download”.
UPDATING THE FIRMWARE
To reset the unit, open the top cover, remove the battery for a few seconds and then
replace it. This will reset the unit but all the default settings (i.e. Radio Presets, Play
mode, Equalizer, Contrast, Power Savings, etc.) will be saved in the unit.
RESETTING THE UNIT