Miele EGW2062 - Manual (Page 16)

~
Before installation make sure that
the voltage and frequency listed on the
data plate correspond with the
household electrical supply. This data
must correspond in order to avoid risk
of damage to the appliance. If in doubt,
consult a qualified technician.
~
The electrical outlet should be easily
accessible after installing the unit.
~
Be sure that after installation the
power cord does not come into contact
with any hot surfaces.
~
Only install the plate warmer in
combination with built-in appliances
recommended by the manufacturer.
When installed with other appliances,
the warranty is void since the
manufacturer cannot guarantee the
safe use of the plate warmer.
~
To install the plate warmer in
combination with another appliance, a
built-in shelf must exist in the cabinet to
support the weight of both appliances.
~
When installed in combination with
another appliance, the plate warmer
must always be installed beneath the
other appliance. The combination
appliance can be set without a base
directly onto the plate warmer. A shelf
between the appliances is not
necessary.
~
To install the combination appliance
please see the manual supplied with
that machine.
~
This appliance is not designed for
maritime use or for use in mobile
installations such as recreational
vehicles or aircraft. However, under
certain conditions it may be possible for
an installation in these applications.
Please contact the Miele Technical
Service Department with specific
requirements.
Note to the installer:
Please leave these instructions with the
consumer of the appliance for the local
building inspectors use.
SAVE THESE
INSTRUCTIONS
IMPORTANT INSTALLATION SAFETY INSTRUCTIONS
16