Miele CS1212 - Manual (Page 22)

Overheating protection
The induction coils and the cooling
element of the electronics are fitted with
an overheating protection feature. This
prevents the induction coils and cooling
element from overheating.
This mechanism works in the following
ways:
– If the booster function is being used,
it will be switched off.
– The power level will be reduced.
– If an induction coil is affected, the
burner will turn off and an
H will
appear in the display.
^ Turn the control knob to "0".
Once the
H has gone out, the combiset
can be used again as normal.
If the control knob is not turned back to
"0",
C and 0 will flash in the display. To
use the burner again, first turn the
control knob to "0".
– If the cooling element is affected, the
power supply to the burner will be
reduced.
Once the cooling element has cooled
sufficiently the burner will continue
working again at the original power
level.
– If the temperature continues to rise
after the power level has been
reduced, the burner will switch off.
C and 0 will flash alternately in the
display.
^ Turn the control knob to "0".
Once the burner has cooled to a safe
temperature the combiset can be used
again as normal.
The overheating protection feature may
be activated by:
– heating an empty pan,
– oils or fats being heated on the
highest power level,
– the underside of the appliance is not
sufficiently ventilated.
If the overheating protection feature
activates again, contact Miele
Technical Service.
Safety features
22