Motion CL900 TABLET PC FWS-001 - Manual (Page 6)

6
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, you are encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
the receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or a radio/television technician for
help.
This device complies with Part 15 of the Federal
Communications Commission (FCC) Rules. Operation is
subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received,
including interference that may cause undesired
operation.
FCC CAUTION: Any changes or modification not expressly
approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
Operation of this wireless communication device is subject
to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received,
including interference that may cause undesired
operation.
WARNING: Do not attempt to service the wireless
communication device built into the Tablet PC yourself.
Such action may void the warranty on the Tablet PC.
Contact your Motion Reseller or Motion Computing for
information about servicing your wireless communication
device.
FCC CAUTION: This device was tested for SAR (Specific
Absorption Rate) in a body-worn and portable
configuration.
The device was found to comply with the FCC
requirements for RF exposure when used in the docking
station, held in the hand, or placed on the lap.
Table on page 7 lists the maximum measured SAR levels for
Motion Tablet PCs.
Note: The Radio Frequency (RF) emitter installed in your
Tablet PC must not be located or operated in conjunction
with any other antenna or transmitter. The 802.11 (WLAN)
and 3G mobile broadband (WWAN) transmitters cannot
function nor transmit at the same time. Before selecting
the radio (WLAN or WWAN) to be used, the user must
disable the radio that will not be used. In addition, the 3G
mobile broadband (WWAN) Connection Manager will alert
the operator to disable WLAN functionality before allowing
connection to the 3G network.
Important: Use Motion Dashboard to disable internal
Tablet PC wireless operations. (Start > All Programs >
Motion Computing > Motion Dashboard) Tap Wireless,
then disable any wireless adapters such as Wi-Fi (802.11),
Bluetooth, and mobile broadband (WWAN).
Modifications
The FCC requires that you be notified that any changes or
modifications made to this device that are not expressly
approved by Motion Computing, Inc. may void your
authority to operate the equipment.
Cables
Connections to this Tablet PC must be made only with
shielded cables. This reduces possible interference with
radio communications and complies with FCC Rules and
Regulations for this EMC classification.
FCC Radiation Exposure Statement
This equipment also complies with FCC RF radiation
exposure limits set forth for an uncontrolled environment,
under 47 CFR 2.1093 paragraph (d)(2), which addresses RF
exposure from radio frequency devices. Operation is within
5.15GHz–5.25GHz frequency range. This frequency range
may limit or restrict the effective use of this equipment to
an indoor environment. This radiated output power is far
below the FCC RF exposure limits. Nevertheless, this device
should be used in such a manner that the potential for
human contact during normal operation is minimized. This
equipment contains an internal antenna transmitter whose
effective use may be affected if it is co-located or operating
in conjunction with any other antenna or transmitter.
Airline travel notice
The FAA requires that you suspend wireless operations
before boarding an airplane. These include both internal
and external wireless devices.
Important: Use Motion Dashboard to disable internal
Tablet PC wireless operations. (Start > All Programs >
Motion Computing > Motion Dashboard) Tap Wireless,
then disable any wireless adapters such as Wi-Fi (802.11),
Bluetooth, and mobile broadband (WWAN).
IC notice (Canada only)
Unintentional Emitter per ICES-003
Motion Computing Tablet PCs are classified by the Industry
Canada (IC) Interference-Causing Equipment Standard #3
(ICES-003) as Class B digital devices.
This Class B (or Class A, if so indicated on the registration
label) digital apparatus meets the requirements of the
Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la Classe B (ou Classe A, si ainsi
indiqué sur l’étiquette d’enregistration) respecte toutes les
exigences du Règlement sur le Matériel Brouilleur du
Canada.
Canada ICES-003,Class B